1. Turn the seaming welt over.
2. Disengage clips A using a fastener remover.
3. Pull the A-pillar trim, then disengage clip B (1).
4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar trim (2).
5. Pull clip B out, then rotate 45°.
6. Remove clip B from the grommet by pulling it toward you.
Mazda 6 Service Manual: Jacking positions ,vehicle lift (2 supports),safety stands (rigid rack)
positions
Jacking Positions
Warning
Improperly jacking a vehicle is dangerous. The vehicle can slip
off the jack and cause serious injury. Use only the correct front and rear
jacking points and block the wheels.
Use safety stands to support the vehicle after it has been lifted.
Fro ...
Mazda 6 Service Manual: Keys
WARNING
Do not leave the key in your vehicle with children and keep them in a place
where your children will not find or play with them: Leaving children in a
vehicle with the key is dangerous. This could result in someone being badly injured
or even killed. Children may find these keys to be ...