Mazda 6 Service Manual: Accelerator pedal removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Accelerator Cable Installation Note
Carry out the ACCELERATOR CABLE INSTALLATION/ADJUSTMENT procedure after installing the accelerator cable. (See ACCELERATOR CABLE INSPECTION/ADJUSTMENT.)
Variable tumble control solenoid valve inspection
1. Remove the variable tumble control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, rep ...
Accelerator cable inspection/adjustment
1. Verify that the throttle valve is closed.
2. Pull the accelerator cable in the directions of A and B, and measure the
free play.
If not as specified, adjust by turning locknut C.
Free ...
Other materials:
Mazda 6 Service Manual: Underbody Maintenance
Road chemicals and salt used for ice and snow removal and solvents used for dust
control may collect on the underbody. If not removed, they will speed up rusting
and deterioration of such underbody parts as fuel lines, frame, floor pan, and exhaust
system, even though these parts may be coated ...
Mazda 6 Service Manual: Stabilizer control link inspection
1. Remove the stabilizer control link from the vehicle.
2. Inspect for bending and damage.
3. Measure the ball joint starting torque.
(1) Rock the ball joint stud side to side 10 times.
(2) Rotate the ball joint stud 10 times.
(3) Measure the starting torque using a suitable allen so ...