1. Slide the lock lever in the direction shown by the arrow to unlock the adjuster.
2. Turn the ratchet ring to release lock in the direction shown by the arrow.
3. Install the actuator cable to the cruise actuator.
Caution
4. Install the cruise actuator. (See CRUISE ACTUATOR REMOVAL/INSTALLATION.)
5. Pass the actuator cable under the accelerator cable.
6. Install the actuator cable to the bracket.
7. Install the grommet to the cable bracket.
8. Move the throttle, and install the end fitting of the actuator cable to the throttle.
Caution
9. To adjust the free play, push or pull the actuator cable directly behind the spring two times.
10. Turn the ratchet ring in the direction shown by the arrow to lock it.
11. Slide the lock lever in the direction shown by the arrow to lock the adjuster.
12. Install the cover to the cruise actuator.
13. Install the plug hole plate.
CRUISE CONTROL SWITCH REMOVAL/INSTALLATION
Note
Mazda 6 Service Manual: Clutch unit removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order oremoval.
Clutch Cover and Disc Removal Note
1. Install the SSTs.
2. Loosen each bolt one turn at a time in a crisscross pattern until spring
tension is released.
3. Remove the clutch cover and disc.
Flywhee ...
Mazda 6 Service Manual: Outside Temperature Display
When the ignition is switched ON, the outside temperature is displayed.
NOTE
Under the following conditions, the outside temperature display may differ
from the actual outside temperature depending on the surroundings and vehicle conditions:
Significantly cold or hot temperatures.
Sudden ...