Mazda 6 manuals

Mazda 6 Service Manual: After repair procedure

Warning

Fuel Leakage Inspection

Warning

Caution

1. Short the check connector terminal F/P to body GND using a jumper wire.


2. Turn the ignition switch to ON position to operate the fuel pump.

3. Pressurize the system in this way for at least 5 minutes

to be sure of no leakage.

4. After repair, assemble the system and repeat Steps 1 to 3.

Before repair procedure
Warning Fuel vapor is hazardous. It can easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leakage are dangerous. Fuel can ig ...

Fuel tank removal/installation
Warning Repairing a fuel tank that has not been properly steam cleaned can be dangerous. Explosion or ire may cause death or serious injury. Always properly steam clean a fuel tank before re ...

Other materials:

Mazda 6 Service Manual: Using Automatic Locking Mode (Some models)
Follow these instructions when using a child-restraint system, unless you are attaching a LATCH-equipped childrestraint system to the rear LATCH lower anchors. Refer to “Using LATCH Lower Anchor”. NOTE Follow the child-restraint system manufacturer's instructions carefully. If you are no ...

Mazda 6 Service Manual: Rear Cross Traffic Alert (RCTA) (Some models)
The Rear Cross Traffic Alert (RCTA) system is designed to assist the driver in checking the area to the rear of the vehicle on both sides while the vehicle is reversing by alerting the driver to the presence of vehicles approaching the rear of the vehicle. The Rear Cross Traffic Alert (RCTA) ...

© 2016-2024 Copyright www.mazda6info.net