Caution
Specified fluid
Note
1. Remove the bleeder cap and attach a vinyl tube to the bleeder screw.
2. Place the other end of the vinyl tube in a clear, fluid-filled container.
3. One person should depress the brake pedal a few times, and then hold it in the depressed position.
4. A second person should loosen the bleeder screw, drain out the fluid and close the screw using the SST
.
Tightening torque Front:6.9-9.8 N·m
{71-99 kgf·cm, 62-86 in·lbf} Rear:5.9-8.8 N·m
{61-89 kgf·cm, 53-77 in·lbf}
5. Repeat steps 3 and 4 until no air bubbles are seen.
6. Bleed air from each component by following the procedure above.
7. After air bleeding, check the following:
Mazda 6 Service Manual: Rearview Mirror
WARNING
Do not stack cargo or objects higher than the seatbacks: Cargo stacked
higher than the seatbacks is dangerous. It can block your view in the rearview mirror,
which might cause you to hit another car when changing lanes.
Rearview mirror adjustment
Before driving, adjust the rearview mi ...
Mazda 6 Service Manual: Underbody Maintenance
Road chemicals and salt used for ice and snow removal and solvents used for dust
control may collect on the underbody. If not removed, they will speed up rusting
and deterioration of such underbody parts as fuel lines, frame, floor pan, and exhaust
system, even though these parts may be coated ...