Mazda 6 Service Manual: Air intake actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air intake actuator.
2. Verify that the air intake actuator operates as shown below.
- If not as specified, replace the air intake actuator.
Air intake actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Air mix actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Other materials:
Mazda 6 Service Manual: Exterior Care
The paintwork on your Mazda represents the latest technical developments in composition
and methods of application.
Environmental hazards, however, can harm the paint's protective properties, if
proper care is not taken.
Here are some examples of possible damage, with tips on how to prevent th ...
Mazda 6 Service Manual: Rear lateral link removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...