Mazda 6 Service Manual: Air intake actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
Control system
...
Air intake actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal
F or D of the air intake actuator.
2. Verify that the air intake actuator operates as shown below.
If not as specif ...
Other materials:
Mazda 6 Service Manual: Generator inspection
Generator Warning Light
1. Verify that the battery is fully charged.
Charge if necessary.
2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT
INSPECTION.)
If not as specified, replace the drive belt.
3. Turn the ignition switch to ON and verify that the gene ...
Mazda 6 Service Manual: Outside Temperature Display (Without Multi-information Display)
When the ignition is switched ON, the outside temperature is displayed.
NOTE
Under the following conditions, the outside temperature display may differ
from the actual outside temperature depending on the surroundings and vehicle conditions:
Significantly cold or hot temperatures.
Sudden ...