Mazda 6 Service Manual: Air mix actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air mix actuator.
2. Verify that the air mix actuator operates as shown below.
- If not as specified, replace the air mix actuator.
e
3. Verify that the resistance between the terminals of the air mix actuator are as shown in the graph.
- If not as specified, replace the air mix actuator.
Air mix actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Airflow mode actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Other materials:
Mazda 6 Service Manual: Shroud panel removal/installation
1. Remove the bonnet. (See BONNET REMOVAL/INSTALLATION.)
2. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)
3. Remove the front combination light. (See FRONT COMBINATION LIGHT
REMOVAL/INSTALLATION.)
4. Remove the front bumper reinforcement. (See BUMPER REINFORCEMENT
REMOVAL/ ...
Mazda 6 Service Manual: No.8 no cool air
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while performing the inspection to discover
whether poor contact points are the cause of any intermittent malfunctions.
If there is a problem, check to make sure connectors, terminals ...