Mazda 6 manuals

Mazda 6 Service Manual: Air mix actuator removal/installation

Mazda 6 Service Manual / Heater and air conditioner systems / Control system / Air mix actuator removal/installation

1. Disconnect the negative battery cable.

2. Remove the glove compartment.

3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)

4. Remove in the order indicated in the table.



5. Install in the reverse order of removal.

Air intake actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air intake actuator. 2. Verify that the air intake actuator operates as shown below. If not as specif ...

Air mix actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air mix actuator. 2. Verify that the air mix actuator operates as shown below. If not as specified, r ...

Other materials:

Mazda 6 Service Manual: Side air bag module removal/installation
Warning Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the air bag module. (See SERVICE WARNINGS.) Warning If the side air bag module is installed with debris in ...

Mazda 6 Service Manual: After repair procedure
Caution After repairing a malfunction, perform this procedure to verify that the malfunction has been corrected. When this procedure is carried out, be sure to drive the vehicle at lawful speed and pay attention to the other vehicles. 1. Connect the WDS or equivalent to the DLC-2. 2. Turn th ...

© 2016-2024 Copyright www.mazda6info.net