Note
1. Connect the SSTs
(WDS or equivalent) to the DLC-2.
2. Turn the ignition switch to ON.
3. Select BARO on the SSTs
(WDS or equivalent).
4. Verify that the BARO PID (pressure) and barometric pressure are practically equal.
- If there is no open or short circuit, replace the barometric pressure sensor.
5. Apply vacuum of -25.0 kPa {-187 mmHg, -7.38 inHg}
to the barometric pressure sensor, and verify that the BARO variation from that of Step 4 is approx. 25.0 kPa {187 mmHg, 7.38 inHg}.
- If there is no open or short circuit, replace the barometric pressure sensor.
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harness for open or short. (Continuity check)
Open circuit
- Barometric pressure sensor terminal A (harness-side) and PCM terminal 1G
- Barometric pressure sensor terminal B (harness-side) and PCM terminal 2H
- Barometric pressure sensor terminal C (harness-side) and PCM terminal 2K
Short circuit
- Barometric pressure sensor terminal C (harness-side) and power supply.
- Barometric pressure sensor terminal C (harness-side) and body GND.
- Barometric pressure sensor terminal A (harness-side) and power supply.
- Barometric pressure sensor terminal A (harness-side) and body GND
Mazda 6 Service Manual: Front seat removal/installation
Warning
Handling the front seat (side air bag) improperly can accidentally
deploy the side air bag, which may seriously injure you. Read AIR BAG SYSTEM
SERVICE WARNINGS before handling the front seat. (See SERVICE WARNINGS.)
1. Turn the ignition switch to the LOCK position.
2. Disconne ...
Mazda 6 Service Manual: Mazda Importer/Distributors
U.S.A.
Mazda North American Operations
7755 Irvine Center Drive
Irvine, CA 92618-2922 U.S.A.
P.O. Box 19734
Irvine, CA 92623-9734 U.S.A.
TEL: 1 (800) 222-5500 (in U.S.A.)
(949) 727-1990 (outside U.S.A.)
CANADA
Mazda Canada Inc.
55 Vogell Road, Richmond Hill, Ontario, L4B 3K5 Canada
TEL: 1 ...