1. Cut away all of the original sealant using a razor.
2. Clean and degrease the ceramic coating on the glass and the base.
3. Apply primer to the bonding area of the glass and the base.
Caution
4. Apply a height of 3.0 mm {0.12 in}
sealant to the base.
Note
5. Center the base in the ceramic coating and press it onto the glass.
6. Use isopropyl alcohol to remove any excess repair sealant.
Hardening time of sealant
7. Install the rearview mirror.
Mazda 6 Service Manual: Battery recharging
Warning
Keep any flammable away from the battery, otherwise evaporated gas
of the battery fluid may catch fire, and cause serious injury or death.
Caution
When removing the battery, disconnect the negative battery cable
first and install it last to prevent damage to electrical compo ...
Mazda 6 Service Manual: Thermostat
THERMOSTAT REMOVAL/INSTALLATION
1. Remove the plug hole plate.
2. Disconnect the negative battery cable.
3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
4. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
5. Remove the washer tank.
6. Remove the P/S oil pump.
Note
...