Mazda 6 Service Manual: Basic system

Refrigerant system service procedures

GAS CHARGING SET INSTALLATION 1. Fully close the valves of the SST (49 C061 001). 2. Connect the SSTs (49 C061 002, 49 C061 003) to the high- and low-pressure side joints of the SST (49 C061 001). ...

Blower unit removal/installation

1. Disconnect the negative battery cable. 2. Remove the dashboard. (See DASHBOARD REMOVAL/INSTALLATION.) 3. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION.) 4. Remove the blower unit. 5 ...

Other materials:

Mazda 6 Service Manual: A/c unit disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. Evaporator Temperature Sensor Assembly Note Assemble the evaporator temperature sensor as shown in the figure. Sensor Clamp Assembly Note Attach the sensor clamp as shown in the figure ...

Mazda 6 Service Manual: Steering angle sensor inspection
With DSC 1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION) 2. Disconnect the steering angle sensor connector. 3. Connect battery positive voltage to terminal A and ground to terminal F of the steering angle sensor. 4. Turn the steering wheel to the right and left, and verify ...