Mazda 6 Service Manual: Battery inspection
Battery
Inspect the battery in the following procedure.
Test load chart
Battery positive voltage with load
Back-up Current
1. Verify that the engine switch is at OFF and that the key has been removed.
2. Disconnect the negative battery cable.
3. Measure the back-up current between the negative battery terminal and the negative battery cable.
- If the current exceeds the maximum, remove the fuses in the main fuse block and the fuse block one by one while measuring the back-up current.
- Inspect and repair harnesses and connectors of the fuse at which the current decreases.
Back-up current
20 mA max.
Caution
- Operating electrical loads while measuring the back-up current can damage the circuit tester.
Battery removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
...
Battery recharging
Warning
Keep any flammable away from the battery, otherwise evaporated gas
of the battery fluid may catch fire, and cause serious injury or death.
Caution
When removing the battery, disc ...
Other materials:
Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2.
2. Set up the WDS (including the vehicle recognition.)
3. Select Module programming.
4. Select Programmable module installation.
5. Select PCM and perform procedures according to directions on the WDS
screen.
Note
If PCM CONFIGURATION is successful, the PCM ...
Mazda 6 Service Manual: STEP 1: Contact Your Mazda Dealer
Discuss the matter with an Authorized Mazda Dealer. This is the quickest and
best way to address the issue.
If your concern has not been resolved by the CUSTOMER RELATIONS, SALES,
SERVICE, or PARTS MANAGER, then please contact the GENERAL MANAGER of the dealership
or the OWNER.
If it b ...