Mazda 6 Service Manual: Blower motor inspection
Connect battery positive voltage to terminal A and ground to terminal B of the blower motor and verify its operation.
- If not as specified, replace the blower motor.
Blower motor removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal. ...
Resistor removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Other materials:
Mazda 6 Service Manual: Owner Maintenance Precautions
The owner or a qualified service technician should make these vehicle inspections
at the indicated intervals to ensure safe and dependable operation.
Bring any problem to the attention of an Authorized Mazda Dealer or qualified
service technician as soon as possible.
At Least Twice a Year (For ...
Mazda 6 Service Manual: Diagnostic trouble code number inspection
1. Remove the glove compartment.
2. Short the A/C check connector to the GND terminal using a jumper wire.
3. Shine a 60 W incandescent light from a height of approximately
100 mm {3.9 in} onto the solar radiation sensor.
Note
When incandescent light does not shine on the solar radiatio ...