Mazda 6 Service Manual: Brake pedal removal/installation
1. For ATX model, remove the lock unit with brake switch (R.H.D. only).
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Brake switch Installation Note
1. Fix the brake switch on a bracket with pressing down at 50 N {5.1 kgf·m, 37 ft·lbf}.
2. Rotate the brake switch 45°
counterclockwise.
3. Verify that the brake switch is locked securely.
Note
- Stopper bolt and pedal stopper clearance adjustment dose not need after the brake switch is locked securely.
Brake switch inspection
1. Disconnect the negative battery cable.
2. Disconnect the brake switch connector harness.
3. Inspect for continuity between the brake switch connector terminals.
If not as specified, replace t ...
Master cylinder removal/installation
1. Remove in the order indicated in the table.
R.H.D.
L.H.D.
2. Install in the reverse order of removal.
Master Cylinder Installation Note
Caution
Always install the gasket of the power ...
Other materials:
Mazda 6 Service Manual: Side air bag module removal/installation
Warning
Handling the air bag module improperly can accidentally deploy the
air bag module, which may seriously injure you. Read AIR BAG SYSTEM SERVICE
WARNINGS before handling the air bag module. (See SERVICE WARNINGS.)
Warning
If the side air bag module is installed with debris in ...
Mazda 6 Service Manual: Variable valve timing actuator inspection
L3
Caution
Variable valve timing actuator can not be disassembled it is a
precision unit.
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
3. Remove the high-tension lead.
4. Remove the oil control valve connector.
5. Remove the ventilation hose.
6. Remove the ...