Mazda 6 Service Manual: Buckle switch inspection
Driver's Seat
1. Disconnect the negative battery cable.
2. Disconnect the buckle switch connector.
3. Inspect for continuity between the buckle switch terminals using an ohmmeter.
- If not as specified, replace the front buckle.
Seat belt inspection
Belt
1. Confirm that the seat belt is installed correctly.
2. Inspect the seat belt for damage and deformation of metal parts.
If any damage is found, replace as necessary.
ELR
1. Verify tha ...
Child restraint seat anchor removal/installation
1. Remove the cover.
2. Remove the bolt and child restraint seat anchor.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Headlight aiming
Low-beam
1. Set up a screen as shown in the figure below for aiming the headlights.
2. Adjust the tire air pressure to the specification.
3. Position the unloaded vehicle on a flat, level surface.
4. Seat one person in the driver's seat.
5. Position the vehicle straight ahead and perpendicu ...
Mazda 6 Service Manual: Information display removal/installation
1. Disconnect the negative battery cable.
2. Remove the center panel module. (See CENTER PANEL MODULE
REMOVAL/INSTALLATION.)
3. Remove the LCD unit. (with car-navigation system) (See LCD UNIT
REMOVAL/INSTALLATION.)
4. Remove the center box. (without car-navigation system)
5. Remove in the or ...