Mazda 6 Service Manual: Bumper reinforcement removal/installation
1. Disconnect the negative battery cable.
2. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)
3. Remove the headlight. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)
4. Suport the radiator and the condenser using the wire.
5. Remove the bolt.
6. Remove the bumper reinforcement.
7. Install in the reverse order of removal.
Front bumper disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly. ...
Rear bumper removal/installation
1. Disconnect the negative battery cable.
2. Remove the rear combination light.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Rear Bumper Removal N ...
Other materials:
Mazda 6 Service Manual: General procedures
PRECAUTION (SUSPENSION)
Wheels and Tires Removal/Installation
When a wheel is installed, tighten it to 88-118 N·m {9.0-12.0 kgf·m,
65.0-87.0 ft·lbf}.
Suspension Links Removal/Installation
Tighten any part of the suspension that uses rubber bushings only after the
vehicle has been lowered ...
Mazda 6 Service Manual: Engine coolant temperature (ect) sensor removal/installation
Warning
When the engine is hot, it can badly burn. Turn off the engine and
wait until it is cool before removing the ECT sensor.
1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
2. Disconnect the ECT sensor connector.
3. Remove the ECT sensor.
4. Install in the reve ...