Caution
Note
Resistance Inspection
1. Disconnect the CMP sensor connector.
2. Measure the resistance between CMP sensor terminals A and B using an ohmmeter.
Specification
400-550 ohms
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harnesses for open or short. (Continuity check)
Open circuit
- CMP sensor terminal A (harness-side) and PCM terminal 2M (harness-side)
- CMP sensor terminal B (harness-siede) and PCM terminal 2J (harness-side)
Short circuit
- CMP sensor terminal A (harness-side) and power supply
- CMP sensor terminal A (harness-side) and body GND
- CMP sensor terminal B (harness-side) and power supply
- CMP sensor terminal B (harness-side) and body GND
Mazda 6 Service Manual: Troubleshooting
Mazda Bluetooth® Hands-Free Customer Service
If you have any problems with Bluetooth®, contact our toll-free customer service
center.
U.S.A. Phone: 800-430-0153 (Toll-free) Web:
www.MazdaUSA.com/bluetooth
Canada Phone: 800-430-0153 (Toll-free) Web:
www.mazdahandsfree.ca
Mexico Cente ...
Mazda 6 Service Manual: Front drain hose installation
Caution
If the front drain hose is pinched or bent anywhere, the water in the hose
may not discharge and enter the inside of the vehicle. During and after
installation of the trims and the headliner, always make sure there is no
interference with the front drain hose. Fix any problem if found ...