Mazda 6 Service Manual: Clutch disc inspection
1. Using vernier calipers, measure the thickness of the lining at a rivet head on both sides.
- Replace the clutch disc if its thickness is less than the minimum.
Thickness
0.3 mm {0.012 in} min.
2. Measure the clutch disc runout using a dial indicator.
- If the runout is excessive, replace the clutch disc.
Runout
0.7 mm {0.028 in} max.
Clutch cover inspection
1. Measure the wear of the diaphragm spring fingers.
If not as specified, replace the clutch cover.
Depth
0.6 mm {0.024 in} max.
2. Measure the flatness of the pressure plate with a s ...
Clutch release collar inspection
Caution
Cleaning the clutch release collar with cleaning fluids or a steam
cleaner can wash the grease out of the sealed bearing.
Turn the collar while applying force in the axial direction. ...
Other materials:
Mazda 6 Service Manual: Seat warmer switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the brake boots panel. (See CONSOLE REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Seat Warmer Switch Removal Note
Squeeze the tabs of seat warmer switch and pull it forwar ...
Mazda 6 Service Manual: Door lock timer unit removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment. (L.H.D.)
3. Remove the bolt.
4. While inclining the door lock timer unit along the body panel in the
direction indicated by the arrow, disengage the bracket hook from the hole in
the body panel.
5. Disconnect the do ...