Mazda 6 manuals

Mazda 6 Service Manual: Combine sensor initialization procedure

Mazda 6 Service Manual / Braking system / Dynamic stability control / Combine sensor initialization procedure

1. Set the SST (WDS or equivalent) to the DLC-2


2. Access the active command mode and select the YAWRATE, then follow the indication on the monitor.

3. Select the LATACCEL and follow the indication on the monitor.

STEERING ANGLE SENSOR REMOVAL/INSTALLATION

(See COMBINATION SWITCH DISASSEMBLY/ASSEMBLY.)

STEERING ANGLE SENSOR INSPECTION

(See STEERING ANGLE SENSOR INSPECTION.)

DSC OFF SWITCH REMOVAL/INSTALLATION

(See TCS (DSC) OFF SWITCH REMOVAL/INSTALLATION.)

DSC OFF SWITCH INSPECTION

(See TCS (DSC) OFF SWITCH INSPECTION.)

Combine sensor inspection
Caution Be careful and do not allow the lateral-G sensor to fall. If by chance it is subjected to strong impact, replace it. 1. Connect the connector. 2. Turn ignition switch on, verify the ...

On-board diagnostic (abs/tcs)
...

Other materials:

Mazda 6 Service Manual: HomeLink Wireless Control System (Some models)
NOTE HomeLink and HomeLink house icon are registered trademarks of Gentex Corporation. The HomeLink system replaces up to 3 hand-held transmitters with a single built-in component in the auto-dimming mirror. Pressing the HomeLink button on the auto-dimming mirror activates garage doors, gates ...

Mazda 6 Service Manual: Front door lock actuator inspection
Door Lock Actuator 1. Disconnect the front door lock actuator connector. 2. Apply battery positive voltage to the front door lock actuator terminals and inspect the operation of the front door lock actuator. If not as specified, replace the front door lock actuator. With double locking ...

© 2016-2024 Copyright www.mazda6info.net