Mazda 6 Service Manual: Condenser inspection
1. Inspect for cracks, damage, and oil leakage.
- If any are found, replace the condenser.
2. Inspect for fins clogged by dust.
- If any are clogged, remove the dust from the fins.
3. Inspect for bent fins.
- If any are bent, use a flathead screwdriver to straighten them.
Condenser removal/installation
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)
3. Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION.)
Caution
...
Refrigerant lines removal/installation
1. Remove the battery.
2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)
3. Remove the washer tank. (L.H.D. only) (See WASHER TANK
REMOVAL/INSTALLATION.)
4. Remove the ...
Other materials:
Mazda 6 Service Manual: Front shock absorber and spring removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-sensor (axle side) and fix it to an appropriate pl ...
Mazda 6 Service Manual: Front combination light removal/installation
Caution
Incorrect servicing of the discharge headlights could result in
electrical shock. Before servicing the discharge headlights, always refer to
the Discharge headlight service warnings. (See DISCHARGE HEADLIGHT
SERVICE WARNINGS)
Note
When the ignition switch is turned to ON, ...