1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)
3. Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION.)
Caution
4. Remove in the order indicated in the table. Do not allow compressor oil to spill.
5. Install in the reverse order of removal.
6. Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST.)
Condenser Installation Note
1. When installing a new condenser, add a supplemental amount of ATMOS GU10 compressor oil inlet the refrigerant cycle.
Supplemental amount (approximate quantity) 20 ml {20 cc, 0.7 fl oz}
Mazda 6 Service Manual: Driving Position Memory (Some models)
The desired driving position can be called up after programming the position.
The following driving positions can be programmed.
Driver’s seat position (seat slide, height adjustment, front edge of seat
bottom, seat recline)
Active driving display (display position, brightness level, dis ...
Mazda 6 Service Manual: Drive belt auto tensioner inspection
1. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
2. Verify that the drive belt auto tensioner moves smoothly in the
operational direction.
Replace the drive belt auto tensioner if necessary.
3. Turn the drive belt auto tensioner pulley by hand and verify that it
rotates smoothly ...