Mazda 6 Service Manual: Conventional brake system

General procedures

PRECAUTION (BRAKES) Wheels and Tires Removal/Installation 1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten i ...

Air bleeding

Caution Maintain the fluid level in the reservoir tank properly while bleeding the air. Specified fluid Note The brakes should be bled whenever a brake line is disconnected. If a h ...

Other materials:

Mazda 6 Service Manual: Diagnostic trouble code number inspection
1. Remove the glove compartment. 2. Short the A/C check connector to the GND terminal using a jumper wire. 3. Shine a 60 W incandescent light from a height of approximately 100 mm {3.9 in} onto the solar radiation sensor. Note When incandescent light does not shine on the solar radiatio ...

Mazda 6 Service Manual: Spark plug removal/installation
1. Disconnect the negative battery cable. 2. Remove the plug hoie plate. Lift off and remove the plug hole plate from the installation areas (rubber and clips) as shown in the figure. 3. Disconnect the high-tension lead. 4. Remove the spark plugs using the plug-wrench. 5. Install th ...