Removal
1. Perform the following procedure to making the working space.
(1) Remove the Front wheel (RH).
(2) Remove the splash shield.
2. Disconnect the CKP sensor connector.
3. Remove the installation bolts to remove the CKP sensor.
Installation
Caution
1. Perform the following procedure so that piston No.1 is at the top dead center.
(1) Remove the front driveshaft (RH). (See DRIVE SHAFT REMOVAL/INSTALLATION.)
(2) Remove the cylinder block lower blind plug and install the SST
.
(3) Turn the crankshaft pulley to the clockwise until it stops.
2. Install the CKP sensor to the CKP sensor installer.
3. Fit the forked part of the CKP sensor installer with the ninth tooth (counting counterclockwise from the empty space) of the pulse wheel.
4. Install the CKP sensor fitting bolts.
Tightening torque 5.5-7.5 N·m {56-76 kgf·cm, 4.1-5.5 ft·lbf}
5. Remove the CKP sensor installer
6. Remove the SST
then install the cylinder block lower blind plug.
Tightening torque 20 N·m {2.0 kgf·m, 15 ft·lbf}
7. Install the front driveshaft (RH). (See DRIVE SHAFT REMOVAL/INSTALLATION.)
Mazda 6 Service Manual: Cargo compartment light switch inspection
1. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
2. Disconnect the cargo compartment light switch connector.
3. Inspect for continuity between the cargo compartment light switch
terminals using an ohmmeter.
If not as specified, replace the liftgate lock.
...
Mazda 6 Service Manual: Location index
INTAKE-AIR SYSTEM
FUEL SYSTEM
Engine Room Side
Fuel tank side
EMISSION SYSTEM
Engine room side
CONTROL SYSTEM
...