Mazda 6 Service Manual: Cruise actuator inspection
1. Disconnect the cruise actuator connector.
2. Measure the voltage, continuity and resistance at the cruise actuator terminals as indicated below.
- If not as specified, inspect the parts listed under Action.
- If the parts and wiring harnesses are okay but the system still does not work properly, replace the cruise actuator.
Terminal Voltage Table (Reference)
Cruise actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Cover Removal Note
Unclamp the clips of the heater hoses at ...
Actuator cable removal
1. Remove the plug hole plate.
2. Remove the cover from the cruise actuator. (See CRUISE ACTUATOR
REMOVAL/INSTALLATION.)
3. Remove the installation nut and pull the cruise actuator toward you.
4. ...
Other materials:
Mazda 6 Service Manual: Jack
To remove the jack
1. Lift the trunk mat.
2. Remove the pocket.
3. Turn the wing bolt and jack screw counterclockwise.
To secure the jack
1. Insert the wing bolt into the jack with the jack screw pointing to the front
and turn the wing bolt clockwise to temporarily tighten it.
2. Turn ...
Mazda 6 Service Manual: Dsc hu/cm removal/installation
Caution
When replacing the DSC HU/CM, configuration procedure must be done
before removing the DSC HU/CM. If configuration is not completed before
removing the DSC HU/CM, DTC B2477 will be detected.
Do not drop the DSC HU/CM. Replace it if it is subjected to an
impact.
1. Configura ...