Warning
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove the headliner.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light illuminates for approximately 6 seconds
and then goes off.
Connector Removal Note
1. Using a flathead screwdriver, pry out the connector's stopper plate.
2. Disconnect the connector.
Curtain Air Bag Module Installation Note (4SD Right Side)
Pass the curtain air bag module harness through the hole in the body.
Mazda 6 Service Manual: Filament repair
1. Use isopropyl alcohol to clean around the damaged section of the filament.
2. Attach tape above and below the damaged section of the filament.
3. Using a small brush or marking pen, repair the filament with silver paint
or equivalent.
4. After 2-3 minutes, carefully remove the tape without ...
Mazda 6 Service Manual: Moonroof (Some models)
The moonroof can be opened or closed electrically only when the ignition is switched
ON.
WARNING
Do not let passengers stand up or extend part of the body through the open
moonroof while the vehicle is moving: Extending the head, arms, or other parts
of the body through the moonroof is dan ...