Mazda 6 Service Manual: Disconnection of the negative battery cable
- Before beginning any work, turn the ignition switch to LOCK position,
then disconnect the negative battery cable and wait for more than 1 minute
to allow the backup power supply of the SAS unit to deplete its stored
power. Disconnecting the battery cable will delete the memories of the
clock, audio, and DTCs, etc. Therefore, it is necessary to verify those
memories before disconnecting the cable.
- If the battery had been disconnected during vehicle maintenance or for
other reasons, the window will not fully close automatically.Carry out the
power window main switch initial setting. (See INITIAL SETTING.)
Use either of the following procedures to identify the type of oil that
is leaking:
Using UV Light (Black Light)
1. Remove on the engine or transaxle.
Note
Referring to the fluorescent ...
While correcting a problem, also try to determine its cause. Begin work
only after first learning which parts and subassemblies must be removed and
disassembled for replacement or repair. Aft ...
Other materials:
Mazda 6 Service Manual: Combine sensor inspection
Caution
Be careful and do not allow the lateral-G sensor to fall. If by
chance it is subjected to strong impact, replace it.
1. Connect the connector.
2. Turn ignition switch on, verify the voltage between terminals B and E
under the following conditions.
If not within the specifi ...
Mazda 6 Service Manual: Foreword
Caution
When the engine does not start or stalls and the following DTCs
are not indicated, go to engine symptom troubleshooting.
Note
When the immobilizer system is defective, the engine cannot be
started.
If engine condition is normal but light stays on, inspect for
short circ ...