1. Remove the transaxle.(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the figure.
3. Install in the reverse order of removal.
Drive Plate Mounting Bolts Removal Note
1. Set the SST
or equivalent against the drive plate.
2. Remove the bolts and the drive plate.
Drive Plate Installation Note
Caution
1. Remove the sealant from the bolts hole in the crankshaft and from the drive plate mounting bolts.
Note
2. Install the drive plate.
3. Install the adapter.
4. Apply sealant to the drive plate mounting bolts and install them.
5. Set the SST or equivalent against the drive plate.
Caution
6. Tighten the drive plate mounting bolts in two or three steps in the order shown.
Tightening torque 108-1116 N·m {11.0-11.8 kgf·m, 80-85 ft·lbf}
7. Install the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION.)
Mazda 6 Service Manual: Windshield wiper arm and blade removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Adjust the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND
BLADE ADJUSTMENT.)
Windshield Wiper Arm Installation Note
Clean the windshield wiper arm connector shafts using a wire brus ...
Mazda 6 Service Manual: Ignition Switch
Push Button Start Positions
The system operates only when the key is within operational range.
Each time the push button start is pressed, the ignition switches in the order
of off, ACC, and ON. Pressing the push button start again from ON switches the ignition
off.
NOTE
The engine star ...