Warning
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Turn the ignition switch to ON position.
6. Verify that the air bag system warning light illuminates for approximately 6 seconds
and then goes off.
Connector Removal Note
1. Using a flathead screwdriver, pry out the connector's stopper plate.
2. Disconnect the connector.
Mazda 6 Service Manual: Rear drain hose installation
Caution
If the rear drain hose is pinched or bent anywhere, the water in the hose may
not discharge and enter the inside of the vehicle. During and after installation
of the trims and the headliner, always make sure there is no interference with
the rear drain hose. Fix any problem if foun ...
Mazda 6 Service Manual: Windshield removal
1. Remove the rearview mirror.
2. Remove the cowl grille.
3. Remove the headliner.
4. Apply protective tape along the edge of the body to protect it from
damage.
5. Apply protective tape to the dashboard to protect it from damage.
6. Cut the lip of the windshield molding using a razor.
War ...