Mazda 6 Service Manual: Dtc 02

Diagnostic trouble code number inspection

1. Remove the glove compartment. 2. Short the A/C check connector to the GND terminal using a jumper wire. 3. Shine a 60 W incandescent light from a height of approximately 100 mm {3.9 in} ont ...

Dtc 06

Diagnostic Procedure ...

Other materials:

Mazda 6 Service Manual: Clutch switch inspection
Note Perform the following inspection only when directed. Continuity Inspection 1. Verify that the clutch switch is installed properly. 2. Disconnect the negative battery cable. 3. Remove the clutch switch. 4. Inspect for continuity between the clutch switch terminals using an ohmmeter. ...

Mazda 6 Service Manual: Pcv valve inspection
1. Disconnect the negative battery cable. 2. Remove the intake maniforld.(see INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 3. Remove the PCV valve. 4. Blow through the valve and verify that air flows as specified. If not as specified, replace the PCV valve. Specification ...