- Place a fan, preferably a vehicle-speed proportional type, in front of the vehicle.
- Make sure the vehicle is in a facility with an exhaust gas ventilation system.
- Since the rear bumper might deform from the heat, cool the rear with a fan. (Surface of the bumper must be below 70 degrees.
)
- Keep the area around the vehicle uncluttered so that heat does not build up.
- Watch the water temperature gauge and dont overheat the engine.
- Avoid added load to the engine and maintain normal driving conditions as much as possible.
Note
and check that the ABS warning light goes off. (In this case, a DTC will be stored in the memory. To delete this data from the memory, follow the procedure for deleting DTCs (ABS) from memory.) (See PRECAUTION (BRAKES) ) to turn off the warning light.)
Mazda 6 Service Manual: Rear door lock actuator inspection
Door Lock Actuator
1. Disconnect the front door lock actuator connector.
2. Apply battery positive voltage to the front door lock actuator terminals
and inspect the operation of the front door lock actuator.
If not as specified, replace the front door lock actuator.
With double locking ...
Mazda 6 Service Manual: Dual proportioning valve inspection (without abs)
1. Connect the SSTs to the brake pipes as shown in the figure.
2. Bleed the air from the brake system.
3. Measure the fluid pressure of the master cylinder and the rear brake.
If not within the specification, replace the dual proportioning valve.
Fluid pressure
...