Mazda 6 Service Manual: Egr valve removal/installation
1. Disconnect the negative battery cable.
2. Disconnect the EGR valve connector.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Water Hose Removal Note
- Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
EGR Valve Removal Note
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION)
2. Remove the upper radiator hose. (See RADIATOR REMOVAL/INSTALLATION.)
Purge solenoid valve inspection
Airflow Inspection
Note
Perform the following test only when directed.
1. Disconnect the negative battery cable.
2. Remove the purge solenoid valve. (See PURGE SOLENOID VALVE
REMOVAL/INSTAL ...
Egr valve inspection
Operation Test
Carry out the EGR Control Inspection. (See EGR Control System
Inspection.
If not as specified, perform the further inspection for the EGR valve.
Resistance Inspection
Note
...
Other materials:
Mazda 6 Service Manual: Pcm removal/installation
Note
For replace the PCM, Setup the WDS and perform the PCM
configuration. (See PCM CONFIGURATION.)
1. Disconnect the negative battery cable.
2. For R.H.D, perform the following procedures.
(1) Remove the front side trim (left-side).
(2) Partially peel back the flower covering.
3 ...
Mazda 6 Service Manual: Changing a Flat Tire
NOTE
If the following occurs while driving, it could indicate a flat tire.
Steering becomes difficult.
The vehicle begins to vibrate excessively.
The vehicle pulls in one direction.
If you have a flat tire, drive slowly to a level spot that is well off the road
and out of the way of tr ...