Warning
1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
2. Disconnect the ECT sensor connector.
3. Remove the ECT sensor.
4. Install in the reverse order of removal.
Tightening torque 10-14 N·m
{1.02-1.42 kgf·m, 7.38-10.32 ft·lbf}
5. Refill the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
Mazda 6 Service Manual: A/c unit disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Evaporator Temperature Sensor Assembly Note
Assemble the evaporator temperature sensor as shown in the figure.
Sensor Clamp Assembly Note
Attach the sensor clamp as shown in the figure ...
Mazda 6 Service Manual: Vehicle speedometer sensor removal/installation
Without ABS
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner compornent. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
4. Disconnect the vehicle speedometer sensor connector.
5. Remove the vehicle speedometer sensor.
6. Apply transmi ...