Mazda 6 Service Manual: Exhaust system
EXHAUST SYSTEM INSPECTION
Start the engine and inspect each exhaust system component for exhaust gas leakage.
- If leakage is found, repair or replace as necessary.
EXHAUST SYSTEM REMOVAL/INSTALLATION
Warning
- When the engine and exhaust system are hot, they can badly burn. Turn off the engine and wait until they are cool before removing the exhaust system.
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
HO2S Removal Note
Remove the HO2S using the SST
before removing the exhaust manifold.
Exhaust Manifold Installation Note
Tighten the exhaust manifold installation nuts in the order shown.
Fuel injector inspection
Operation Test
Carry out the Fuel Injector Operation Inspection. (See Fuel Injector
Operation Inspection.)
If not as specified, perform the further inspection for the fuel
injectors.
Resi ...
Emission system
...
Other materials:
Mazda 6 Service Manual: Control valve body installation
On-Vehicle Installation
Caution
Be sure to align the parking rod and the manual valve.
1. Install the accumulator springs and accumulators into the transaxle case.
2. Install the control valve body component.
Tightening torque
7.8-10.8 N·m
{80-110 kgf·cm, 70-95 in·lbf}
Bo ...
Mazda 6 Service Manual: Odometer, Trip Meter and Trip Meter Selector
The odometer is constantly displayed on the screen when the ignition is switched
ON, and the TRIP A or TRIP B screen can be displayed by operating the INFO switch.
Odometer
The odometer records the total distance the vehicle has been driven.
Trip meter
The driving distance for a specified in ...