FRONT FLOOR COVERING REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front seats. (See FRONT SEAT REMOVAL/INSTALLATION.)
3. Remove the rear seat.
4. Remove the front scuff plates.
5. Remove the rear scuff plates.
6. Remove the console.
7. Remove the front side trims.
8. Remove the B-pillar lower trims.
9. Remove the lower anchor of the front seat belt installation bolts.
10. Remove the tire house trim. (5HB)
11. Remove the fuel-filler lid opener bezel.
12. Remove the fasteners.
13. Remove the cap nuts.
14. Remove the clips.
15. Take the front floor covering off from the passenger-side door opening.
16. Install in the reverse order of removal.
Mazda 6 Service Manual: Air intake actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal
F or D of the air intake actuator.
2. Verify that the air intake actuator operates as shown below.
If not as specified, replace the air intake actuator.
...
Mazda 6 Service Manual: System Canceling
When the Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS)
is turned off, press the Lane-keep Assist System (LAS) & Lane Departure Warning
System (LDWS) OFF switch.
The Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) OFF
indicator light tu ...