Mazda 6 manuals

Mazda 6 Service Manual: Foreword

- If a DTC exists, diagnose the applicable DTC inspection. (See DTC TABLE.)

- If no DTC exists and the MIL does not illuminate or flash, diagnose the applicable symptom troubleshooting. (See ENGINE SYMPTOM TROUBLESHOOTING.)


* : Malfunction Indicator lamp (MIL), Generator Warning Light, Security Light

OBD PENDING TROUBLE CODES

2 Drive Cycle Type

1 Drive Cycle Type

OBD FREEZE FRAME DATA

OBD ON-BOARD SYSTEM READINESS TEST

OBD DIAGNOSTIC MONITORING TEST RESULTS

OBD READ/CLEAR DIAGNOSTIC TEST RESULTS

OBD PARAMETER IDENTIFICATION (PID) ACCESS

On-board diagnostic
...

On-board diagnostic test
DTCs Reading Procedure 1. Perform the necessary vehicle preparation and visual inspection. 2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 3. ...

Other materials:

Mazda 6 Service Manual: General procedures
Wheels and Tires Removal/Installation The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}. Power Steering Components Removal/Installation If any power steeri ...

Mazda 6 Service Manual: Manifold absolute pressure (map) sensor inspection
Note Perform the following inspection only when directed. The following vacuum values are indicated by relative pressure from the MAP sensor. 1. Connect the SSTs (WDS or equivalent) to the DLC-2. 2. Turn the ignition switch to ON (Engine OFF). 3. Select MAP PID on the SSTs (WDS or equi ...

© 2016-2024 Copyright www.mazda6info.net