Mazda 6 Service Manual: Front beltline molding installation
1. Press the clip into the body.
2. Press in the B section of the front beltline molding along the direction (1) shown in the figure to attach it to the body.
Note
- If the front beltline molding is difficult to attach, apply soapy water.
Front beltline molding removal
Note
When removing the front beltline molding, the clip may be damaged. If
the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the ...
Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B ...
Other materials:
Mazda 6 Service Manual: Adaptive Front Lighting System (AFS) (Some models)
The adaptive front lighting system (AFS) automatically adjusts the headlight
beams to the left or right in conjunction with the operation of the steering wheel
after the headlights have been turned on and the vehicle speed is about 2 km/h (2
mph) or higher.
A system malfunction or operation c ...
Mazda 6 Service Manual: SRS Air Bag Deployment Criteria
This chart indicates the applicable SRS equipment that will deploy depending
on the type of collision.
(The illustrations are the representative cases of collisions.)
X: The SRS air bag equipment is designed to deploy in a collision.
*1 (With Front Passenger Occupant Classification System) Th ...