Mazda 6 Service Manual: Front bumper removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Front Bumper Removal Note
1. Pull the front bumper ends (wheel arch) outward to disengage from the bumper slider.
Caution
- If only one side of the front bumper is disengaged from the bumper slider and the bumper falls, it could be damaged. When disengaging the front bumper from the slider, secure the bumper so that it does not fall.
2. Remove the front bumper from the body.
Front Bumper Installation Note
1. Spread the front bumper ends (wheel arches) apart.
2. Attach the front bumper to the body.
3. Press the front bumper connection portion into the body to engage with the bumper slider.
Bumper
...
Front bumper disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly. ...
Other materials:
Mazda 6 Service Manual: Installation of radio system
If a radio system is installed improperly or if a high-powered type is used,
the CIS and other systems may be affected. When the vehicle is to be equipped
with a radio, observe the following precautions:
Install the antenna at the farthest point from control modules.
Install the antenna fe ...
Mazda 6 Service Manual: To Temporarily Cancel
To temporarily cancel the system, use one of these methods:
Slightly depress the brake pedal.
(Manual transaxle) Depress the clutch pedal.
Press the OFF/CANCEL switch.
If the RESUME/ switch is
pressed when the vehicle speed is 25 km/h (16 mph) or higher, the system reverts
to the prev ...