1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Front Lower Arm (Front) Ball Joint Removal Note
Separate the ball joint from the knuckle using the SSTs
.
Front Lower Arm (Front) Bushing (Inner Side) Removal Note
Press the bushing (inner side) out using the SSTs
.
Front Lower Arm (Front) Bushing (Outer Side) Removal Note
Press the bushing (outer side) out using the SSTs
.
Front Lower Arm (Front) Bushing (Outer Side) Installation Note
1. Mark the new bushing as shown in the figure.
2. Press the bushing in to the marking using the SSTs
.
3. Verify that clearance distance AB is 8.75 mm - 10.75 mm {0.3445 in - 0.4232 in}.
Front Lower Arm (Front) Bushing (Inner Side) Installation Note
1. Mark the new bushing as shown in the figure.
2. Press the bushing in to the marking using the SSTs
.
3. Verify that clearance distance AB is 12.75 mm - 14.75 mm {0.5020 in - 0.5807 in}.
Clip Installation Note
1. Wipe the grease off the ball stud.
2. Fill the inside of the new dust boot with grease.
3. Install the boot on the ball joint.
4. Install the new clip using the SST
.
5. Verify that the clip is installed securely to the groove.
6. Wipe away the excess grease.
Mazda 6 Service Manual: Audio Operation Using Voice Recognition
Voice command
When the talk button is pressed and the following command is spoken, the audio
or navigation can be operated. The commands in the () can be omitted. The specified
name and number are put into the {}.
Standard command
Communication (phone) related command
Entertainment (audi ...
Mazda 6 Service Manual: Bright-Metal Maintenance
Use tar remover to remove road tar and insects. Never do this with a knife
or similar tool.
To prevent corrosion on brightmetal surfaces, apply wax or chrome preservative
and rub it to a high luster.
During cold weather or in coastal areas, cover bright-metal parts with a
coating of ...