Mazda 6 manuals

Mazda 6 Owners Manual: Front Passenger Occupant Classification Sensor

Your vehicle is equipped with a front passenger occupant classification sensor as a part of the supplemental restraint system. This sensor is equipped in the front passenger's seat cushion. This sensor measures the electrostatic capacity of the front passenger's seat. The SAS unit is designed to prevent the front passenger front and side air bags and seat belt pretensioner system from deploying if the front passenger air bag deactivation indicator light turns on.

To reduce the chance of injuries caused by deployment of the front passenger air bag, the system deactivates the front passenger front and side air bags and also the seat belt pretensioner system when the front passenger air bag deactivation indicator light turns on. Refer to the following table for the front passenger air bag deactivation indicator light illumination conditions.

This system shuts off the front passenger front and side air bags and seat belt pretensioner system, so make sure the front passenger air bag deactivation indicator light turns on according to the following table.

The air bag/front seat belt pretensioner system warning light flashes and the front passenger air bag deactivation indicator light illuminates if the sensors have a possible malfunction. If this happens, the front passenger front and side air bags and seat belt pretensioner system will not deploy.

Front Passenger Occupant Classification System (Some models)
First, please read "Supplemental Restraint System (SRS) Precautions" carefully. ...

Front passenger air bag deactivation indicator light
This indicator light turns on to remind you that the front passenger front and side air bags and seat belt pretensioner will not deploy during a collision.   If the front passenger occupant ...

Other materials:

Mazda 6 Owners Manual: Disconnection of the negative battery cable
Before beginning any work, turn the ignition switch to LOCK position, then disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS unit to deplete its stored power. Disconnecting the battery cable will delete the memories of the ...

Mazda 6 Owners Manual: Drive belt auto tensioner inspection
1. Remove the drive belt. (See DRIVE BELT REPLACEMENT.) 2. Verify that the drive belt auto tensioner moves smoothly in the operational direction. Replace the drive belt auto tensioner if necessary. 3. Turn the drive belt auto tensioner pulley by hand and verify that it rotates smoothly ...

© 2016-2024 Copyright www.mazda6info.net