Visual Inspection
Remove the wheel and tire, and inspect the sensor for looseness and damage. Replace the sensor if necessary.
Clearance Inspection
Inspect the clearance between the wheel-speed sensor and the sensor rotor.
Clearance
0.3-1.1 mm {0.012-0.043 in}
Resistance Inspection
1. Disconnect the ABS wheel-speed sensor connector.
2. Inspect the resistance at the ABS wheel-speed sensor.
Resistance
1.3-1.7 kilohm
Voltage Inspection
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Disconnect the ABS wheel-speed sensor connector.
3. Inspect each sensor by rotating each wheel one revolution per second.
Voltage
0.25-1.2 V (AC)
Voltage Pattern Inspection
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Disconnect the ABS wheel-speed sensor connector.
3. Using an oscilloscope, inspect voltage pattern for distortion and noise by rotating each wheel.
Mazda 6 Service Manual: Removing a Flat Tire
1. Loosen the lug nuts by turning them counterclockwise one turn each, but do
not remove any lug nuts until the tire has been raised off the ground.
2. Place the jack on the ground.
3. Turn the jack screw in the direction shown in the figure and adjust the jack
head so that it is close to th ...
Mazda 6 Service Manual: Seat warmer unit inspection
1. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.)
2. Remove the seat cushion trim.
3. While inspecting for continuity between the terminals A and B of the
connector, use a dryer to warm the thermostat of the seat warmer unit on seat
cushion.
4. When the indication on the ohmm ...