Mazda 6 Service Manual: Front scuff plate removal/installation
1. Pull the front scuff plate upward, then disengage clips B, pins C, D and hooks E from the body, and remove the front scuff plate.
2. Install in the reverse order of removal.
Front side trim removal/installation
1. Remove the front scuff plate.
2. Turn the seaming welt over.
3. Pull the front side trim toward you, then disengage clip A and the stud
bolt, then remove the front side trim.
4. Install in t ...
Rear scuff plate removal/installation
1. Pull the rear scuff plate upward, then disengage clips A, pin B, and hooks
C from the body, and remove the rear scuff plate.
2. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Headlight zeroset
Note
When the configuration is not set for the auto leveling control unit,
headlight zeroset cannot be executed.
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Connect the SST (WDS or equivalent) to the DLC-2.
4. Turn t ...
Mazda 6 Service Manual: Side protector installation
1. Remove the adhesive remaining on the side protector (if it will be reused)
and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the side protector
(if it will be reused) and the body.
3. Attach double-sided adhesive tape to the side protector as shown (if it ...