Mazda 6 Service Manual: Fuel pump unit disassembly/assembly
Warning
- Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this, do not damage the sealing surface of the fuel pump unit when removing or installing.
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Fuel pump unit removal/installation
Warning
Fuel line spills and leakage are dangerous. Fuel can ignite and
cause serious injuries or death and damage. Fuel can also irritate skin and
eyes. To prevent this, do not damage the s ...
Fuel pump unit inspection
Caution
It is normal to hear the fuel pump operating when the ignition
switch is turned to the ON position.
Note
To improve startability, the fuel pump control operates the fuel
pump ...
Other materials:
Mazda 6 Service Manual: Starter inspection
On-vehicle Inspection
1. Verify that the battery is fully charged.
2. Crank the engine and verify that the starter rotates smoothly without any
noise.
If not, inspect the following.
- Remove the starter and inspect the magnetic switch and the starter.
- Inspect the related wiring har ...
Mazda 6 Service Manual: Refrigerant system service procedures
GAS CHARGING SET INSTALLATION
1. Fully close the valves of the SST (49 C061 001).
2. Connect the SSTs (49 C061 002, 49 C061 003) to the high- and
low-pressure side joints of the SST (49 C061 001).
3. Connect the SSTs (49 C061 006A, 49 C061 007) to the ends of the
SSTs (49 C061 002, 49 C061 00 ...