Mazda 6 manuals

Mazda 6 Service Manual: Glass panel adjustment

Mazda 6 Service Manual / Body / Sliding sunroof / Glass panel adjustment

1. Fully close the glass panel.

2. Measure the gap and height between the glass panel and body.

3. If not as specified, loosen the glass panel installation screws and reposition the glass panel.

Clearance
a: -0.8-1.2 mm {-0.032-0.047 in} b: 0 mm {0 in}

4. Tighten the installation screws.



5. Insert a prepaid card between the weatherstrip and the body of the vehicle. Verify that the sunroof is shut tightly (there is resistance when the prepaid card is moved).

Glass panel removal/installation
1. Fully close the glass panel. 2. Fully open the sunshade. 3. Remove the screws, and then remove the glass panel. 4. Peel the weatherstrip off the glass panel. 5. Install in the reverse order ...

Front drain hose removal
1. Remove the headliner. 2. Disconnect the front drain hose from the sunroof frame. 3. Remove the front drain hose from the clips. 4. Pull the front drain hose into the room side. 5. Remove the fr ...

Other materials:

Mazda 6 Service Manual: Engine Start Function When Key Battery is Dead
CAUTION When starting the engine by holding the transmitter over the push button start due to a dead key battery or a malfunctioning key, be careful not to allow the following, otherwise the signal from the key will not be received correctly and the engine may not start. Metal parts of ot ...

Mazda 6 Service Manual: Disconnection of the negative battery cable
Before beginning any work, turn the ignition switch to LOCK position, then disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS unit to deplete its stored power. Disconnecting the battery cable will delete the memories of the ...

© 2016-2024 Copyright www.mazda6info.net