Mazda 6 manuals

Mazda 6 Service Manual: Glove compartment removal/installation

Mazda 6 Service Manual / Body / Dashboard and console / Glove compartment removal/installation

1. Pull the stay damper to the direction shown in the figure. Then detach the fit for the glove compartment from the stay damper.


2. Bend the stoppers inward to remove.


3. Turn the glove compartment downward and pull the clips to remove it.

4. Install in the reverse order of removal.

Center box removal/installation
1. Disconnect the negative battery cable. 2. Remove the center panel module. 3. Remove the screws. 4. Pull the center box forward, then disengage the tabs 5. Disconnect the LDC unit connector. ...

Console removal/installation
1. For MT vehicle, remove the shift lever knob. 2. Remove the cup holder panel using a tape-wrapped screwdriver. 3. Remove the boot panel using a tape-wrapped screwdriver, disconnect the cigaret ...

Other materials:

Mazda 6 Service Manual: Control valve body installation
On-Vehicle Installation Caution Be sure to align the parking rod and the manual valve. 1. Install the accumulator springs and accumulators into the transaxle case. 2. Install the control valve body component. Tightening torque 7.8-10.8 N·m {80-110 kgf·cm, 70-95 in·lbf} Bo ...

Mazda 6 Service Manual: Driving Position Memory (Some models)
The desired driving position can be called up after programming the position. The following driving positions can be programmed. Driver’s seat position (seat slide, height adjustment, front edge of seat bottom, seat recline) Active driving display (display position, brightness level, dis ...

© 2016-2024 Copyright www.mazda6info.net