Mazda 6 manuals

Mazda 6 Service Manual: Headlight leveling switch removal/installation

Mazda 6 Service Manual / Body electrical system / Exterior lighting system / Headlight leveling switch removal/installation

1. Disconnect the negative battery cable.

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

Headlight Leveling Switch Removal Note

1. Insert your hand from the lower side of the dashboard and squeeze the tabs of the headlight leveling switch.

2. Pull the headlight leveling switch forward to remove it.



HEADLIGHT LEVELING SWITCH INSPECTION

1. Remove the headlight leveling switch. (See HEADLIGHT LEVELING SWITCH REMOVAL/INSTALLATION.)

2. Inspect for continuity between the headlight leveling switch terminals using an ohmmeter.

Front and rear fog light switch inspection
Light switch LH side 1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION.) 2. Inspect for continuity between the light switch terminals using an ohmmeter. If not as specified, r ...

Back-up light switch removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table.     3. Install in the reverse order of removal. ...

Other materials:

Mazda 6 Service Manual: Condenser removal/installation
4SD 1. Disconnect the negative battery cable. 2. Remove the rear package trim. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 5HB 1. Disconnect the negative battery cable. 2. Remove the liftgate lower trim. 3. Remove in the order indicated in t ...

Mazda 6 Service Manual: Power Moonroof Reset Procedure
If the battery is disconnected, the moonroof will not operate. The moonroof will not operate correctly until it is reset. Carry out the following procedure to reset the moonroof and resume operation: 1. Switch the ignition ON. 2. Press the tilt switch, to partially tilt open the rear of the moo ...

© 2016-2024 Copyright www.mazda6info.net