Mazda 6 Service Manual: Heater core inspection
1. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION.)
2. Remove the heater core from the A/C unit.
3. Inspect for cracks, damage, and coolant leakage.
- If any problems are found, replace the heater core.
4. Inspect for bent fins.
- If any are bent, use a flathead screwdriver to straighten them.
5. Verify that the heater core inlet and outlet pipe are not distorted or damaged.
- Repair with pliers if necessary.
Evaporator inspection
1. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION.)
2. Remove the evaporator from the A/C unit.
3. Inspect for cracks, damage, and oil leakage.
If any problems are found, replace the ev ...
Rear heat duct removal/installation
1. Turn over the front floor covering. (See FRONT FLOOR COVERING
REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Oil pan
OIL PAN REMOVAL/INSTALLATION
Warning
Hot engine and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine oil have cooled.
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Drain the engine oil. (See ENGINE OIL REPLACEMENT.)
4. Re ...
Mazda 6 Service Manual: Audio control switch removal/installation
Note
The audio control switch and the cruise control switch use a
common connector.
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION.)
3. Remove the steering wheel.
4. Remove in the order indicated ...