Mazda 6 manuals

Mazda 6 Owners Manual: High Beam Control System (HBC) (Some models)

Mazda 6 Owners Manual / When Driving / i-ACTIVSENSE / High Beam Control System (HBC) (Some models)

The High Beam Control System (HBC) determines the conditions in front of the vehicle using the Forward Sensing Camera (FSC) while driving in darkness to automatically switch the headlights between high and low beams.

Refer to Warning/Indicator Lights.

While driving the vehicle at a speed of about 30 km/h (19 mph) or more, the headlights are switched to high beams when there are no vehicles ahead or approaching in the opposite direction.

The system switches the headlights to low beams when one of the following occurs:


The warning light turns on when the system has a malfunction.

Refer to Warning Indication/Warning Lights.

CAUTION

NOTE

The timing in which the system switches the headlights changes under the following conditions. If the system does not switch the headlights appropriately, manually switch between high and low beams according to the visibility as well as road and traffic conditions.

Adaptive Front Lighting System (AFS) (Some models)
The adaptive front lighting system (AFS) automatically adjusts the headlight beams to the left or right in conjunction with the operation of the steering wheel after the headlights have been turne ...

To Operate the System
The High Beam Control System (HBC) operates to switch the headlights automatically between high and low beams after the ignition is switched ON and the headlight switch is in the AUTO and high bea ...

Other materials:

Mazda 6 Owners Manual: Condenser removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION.) Caution If moisture or foreign material enters the refrigeration cycle, cooling ability will be lower ...

Mazda 6 Owners Manual: Transaxle range (tr) switch adjustment
1. Disconnect the negative battery cable. 2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) Caution Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector w ...

© 2016-2024 Copyright www.mazda6info.net