Mazda 6 Service Manual: Ignition switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Fuse block removal/installation
1. Disconnect the negative battery cable.
2. Remove the left-side front side trim. (See FRONT SIDE TRIM
REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the ...
Ignition switch inspection
1. Disconnect the negative battery cable.
2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
3. Disconnect the ignition switch connectors.
4. Inspect for continuity between the ign ...
Other materials:
Mazda 6 Service Manual: Oil seal (differential) replacement
1. On level ground, jack up the vehicle and support it evenly on safety
stands.
2. Drain the oil from the transaxle.
3. Remove the front wheels and splash shields.
4. Separate the drive shaft and joint shaft from the transaxle. (See DRIVE
SHAFT REMOVAL/INSTALLATION.) (See JOINT SHAFT REMOVAL/ ...
Mazda 6 Service Manual: Inspection of sst (deployment tool)
Use the SST (Deployment tool) to deploy a live (undeployed) air bag
module or pre-tensioner seat belt before disposing of it.
Before using the SST (Deployment tool), inspect its operation.
Inspection Procedure
Follow the steps below to verify that the SST (Deployment tool) is
operatin ...