Note
- The battery has been disconnected during vehicle maintenance or for other reasons.
- The power window main switch connector, or driver-side power window motor connector has been disconnected.
1. Turn the ignition switch to the ON position.
2. Press the driver side power window main switch and fully open the driver side window.
3. Pull up the driver side power window main switch to manual-up position to fully close the driver side window, and keep holding the switch up at the position for about 2 seconds
to complete initial setting.
Mazda 6 Service Manual: Air bag module and pre-tensioner seat belt disposal procedures
Warning
Before scrapping a vehicle with a live (undeployed) air bag module
and pre-tensioner seat belt, deploy the air bag module and pre-tensioner
seat belt. Never dispose of a live (undeployed) air bag module and pre-tensioner
seat belt.
The air bag module and the pre-tensioner seat ...
Mazda 6 Service Manual: Rear door speaker removal/installation
1. Disconnect the negative battery cable.
2. Remove the rear door trim.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Rear Door Speaker Installation Note
Attach the speaker with the wiring harness placed in the groove of the door
unit panel.
...